Flamco T-Plus DN80 × Rp 1¼" cast iron tapping saddle, PN 25
- Pipe size: DN80 (3", ~89 mm OD)
- Branch connection: Rp 1¼" female thread
- Working pressure / temperature: PN 25 / up to 130 °C
- Body material: cast iron with anti-corrosion coating
Where T-Plus DN80 is used
DN80 is the typical mainline size for larger commercial substations or district-heating tap-ins. T-Plus DN80 enables adding a sensor pocket, measurement point, DHW module tap or auxiliary pump without shutting down the whole node — critical where welding would suspend heating for dozens or hundreds of users (multi-family block, office centre, school or hospital).
Technical specifications
| Parameter | Value |
|---|---|
| Code | 90680 |
| Manufacturer | Flamco (Aalberts HFC) |
| Series | T-plus cast iron |
| Nominal pipe diameter | DN80 (3") |
| Branch connection | Rp 1¼" (female thread) |
| Nominal pressure PN | 25 bar |
| Max operating temperature | 130 °C |
| Body material | Cast iron with anti-corrosion coating |
| Compatible pipes | Steel (St33/34/35/37) per DIN 2441 / NEN 3257 C Heavy / BS 1387 Heavy |
| Wall thickness (steel DN80) | ~4.5-5.0 mm (Heavy grade) |
| Media | Water, glycol solutions up to 50 %, compressed air |
| Piercing mechanism | Single-shot, integrated |
When to choose T-Plus DN80
- Larger commercial DN80 mainline branches
- DH network tap-in secondary user nodes
- Renovations that must keep most users heated
- Industrial mainline sensor points
- Compatibility: DN80 Heavy grade steel — verify wall before installation
B2B delivery and logistics via Amegata.lt
- 24-hour delivery across Lithuania (from our warehouse in Vilnius)
- Competitive B2B pricing — often below market average
- 30-day payment terms for companies (per contract)
- Free technical consultation on pipe compatibility
Official Flamco catalogue: flamcogroup.com/T-plus
Frequently asked questions
Is Rp 1¼" branch capacity enough for a DN80 mainline?
Depends on the branch purpose. Sensor pockets, measurement points, or secondary loop tap-ins (up to ~25 m³/h) — sufficient. For larger flow, plan a system drain-down and welded tee.
Suitable for compressed air networks?
Yes. T-Plus is suitable for industrial compressed air up to PN 25. Before installation, ensure that swarf from piercing does not enter the flow (install an inline strainer downstream).
Glycol mixtures allowed?
Yes, up to 50 % ethylene or propylene glycol with proper inhibitors.
What maintenance is required?
Installed T-Plus needs no periodic service. Annual visual check recommended (corrosion, leak signs).
Suitable for potable water systems?
The cast iron version targets sealed heating/cooling systems. For potable water, use the Flamco T-Plus brass or stainless variant — contact us for the correct code.
